Why no H20-100 Firmware Thread

[1948GG]

Why is there no firmware thread, either in this part of the forum, or in the s/w Release Forum? There is for the older H20-600, however.

[ATARI]

For some reason it never got 'stickied'.

Try this thread (http://www.dbstalk.com/showthread.php?t=111577).

[1948GG]

For some reason it never got 'stickied'.

Try this thread (http://www.dbstalk.com/showthread.php?t=111577).

Well, since it got upgraded today with 0x404a (which is 'labeled' as 'Fall 2007') I would say it's long overdue. Don't know if it's on any 'roll-out' schedule, but as I'm way up in the extreme Pacific Northwest, and with the roll-outs of other machine specific s/w upgrades, it probably is (national, that is).

[jwd45244]

Well, since it got upgraded today with 0x404a (which is 'labeled' as 'Fall 2007') I would say it's long overdue. Don't know if it's on any 'roll-out' schedule, but as I'm way up in the extreme Pacific Northwest, and with the roll-outs of other machine specific s/w upgrades, it probably is (national, that is).

0x404a is a Cutting Edge release. There is a thread about it in the Cutting Edge Forum.

[Stuart Sweet]

Sorry for that omission, it's been fixed.

[1948GG]

Sorry for that omission, it's been fixed.

Great, especially as virtually all of the customers of the companies I do engineering support for 'flushed out' the H20-600's a LONG time ago, with only a couple of non-MDU folks holding on to the older units, that had a VERY high failure rate (either 'out of the box' or after a few months of use).

Again, Great!

[Stuart Sweet]

Please note the national rollout of the new software has started, and a new thread is already there for that.

[JJJBBB]

Please note the national rollout of the new software has started, and a new thread is already there for that.
k !