Using remote for Azimuth/elevation

[foothill]

I tried to use my remote to find the angles for the dish by using the zip codes and can only get the remote to show step 6 of 9; it won't start at step 1.

Did I overlook something??

[GTS]

Press menu, get to the Setup menu. Select Satellite menu. You should see the Reset Satellite Settings option. This should take you to step 1.

Hope it helps.

[K4SMX]

Or you could go to dishpointer.com (htto://www.dishpointer.com), input your exact location, and then make your dish selection. The round dish and the 5 LNB use 101W, and the 3 LNB Phase III dish uses 110W.

[foothill]

When I looked at the 'reset' option, it gave a warning that other items would be erased, like favorites, etc.

[GTS]

When I looked at the 'reset' option, it gave a warning that other items would be erased, like favorites, etc.

I apologize....
Go to Setup menu. Select Satellite menu, same menu route to see signal levels. On the satellite menu page you should see the option to Repeat Satellite Setup. This will bring you back to step 2.

Tried to go from memory... About as hard for me to walk and chew gum at the same time.