OOPPS!! What did I mess up?

[roadrunner1782]

Someone help, I just unplugged my HR22-100 "accidently" from my surge protector because i needed to plug in a new wireless router i just bought (plug was big and needed to go where the ird was plugged in. Anyways now the reciever is searching for sat signal (771) and when i checked the signal strength besides random transponders being 0 it doesnt show the swm transponders. I have a swm lnb sorry i didnt mention that sooner, also the other recievers are working fine it just seems the HR22 doesnt realize what it is hooked to!:eek2: I've done RBR twice and still nothing!! Any ideas??

[houskamp]

try disconecting the sat lines from the other recievers and see if the hr22 will come up right.. I had this once and it seemed to be 'seeing' the other recievers as a standard lnb.. a cheap splitter in the line fixed it..

[Richierich]

If that doesn't work wouldn't repeating the Satellite Guided Setup work as far as having the DVR recognize the type or dish it has or you could just tell it what you have.

I repeated that setup and now my DVR is responding alot faster than it did before I went back into that setup and reran it.

[repulski]

Try a rbr

[RobertE]

The power inserter is still plugged in right?

You could also reset the entire system by unpluggin all receivers and the PI, the plugging back in the PI and then the receivers

[Grentz]

The power inserter is still plugged in right?

You could also reset the entire system by unpluggin all receivers and the PI, the plugging back in the PI and then the receivers

This is the first thing I would try.

Worked for me on my SWM setup when I was having some issues with one of my receivers not seeing all the satellites properly.

[SDizzle]

Someone help, I just unplugged my HR22-100 "accidently" from my surge protector because i needed to plug in a new wireless router i just bought (plug was big and needed to go where the ird was plugged in. Anyways now the reciever is searching for sat signal (771) and when i checked the signal strength besides random transponders being 0 it doesnt show the swm transponders. I have a swm lnb sorry i didnt mention that sooner, also the other recievers are working fine it just seems the HR22 doesnt realize what it is hooked to!:eek2: I've done RBR twice and still nothing!! Any ideas??

Has your problem been corrected yet with any ideas here??:)

[roadrunner1782]

Yeah it's working again. I did what RobertE said just without unplugging the other receivers and it finally started working right!! Thanks to everyone for the input!!!!