4HiMarks
06-15-09, 07:38 AM
Over the weekend I was attempting to rescan my locals due to the frequency change of some of them after the transition. My 622 would work normally, until the OTA tuner was needed (check signal strength, etc.) and then it would re-boot. I eventually managed to get it tuned to a OTA station (one which didn't move) that will come in for less than a second, then it reboots again. So my receiver is essentially unusable. Is there any way to get it out of this loop?
It is my secondary box, so I can still watch TV, but there have been issues with it rebooting before. Of course once I called CS, it cleared up. I have been hesitant to call at the present time because I expect they are inundated with calls related to the digital transition and I don't want to sit on hold forever.
It is my secondary box, so I can still watch TV, but there have been issues with it rebooting before. Of course once I called CS, it cleared up. I have been hesitant to call at the present time because I expect they are inundated with calls related to the digital transition and I don't want to sit on hold forever.