How To Make UHF Remote Primary?

[RoughDobermann]

Well, I got my replacement 722 (which has 6.18 firmware and if they upgrade to 6.21, I'll set it on fire). I had my old 722 setup to have the UHF remote control it since it is in a wooden cabinet and IR won't work. For the life of me, I cannot figure out how to make the new 722 work with my old UHF remote. Can anyone help please? I called Dish and they were pathetic.

My thanks.

[RoughDobermann]

Well, I got my replacement 722 (which has 6.18 firmware and if they upgrade to 6.21, I'll set it on fire). I had my old 722 setup to have the UHF remote control it since it is in a wooden cabinet and IR won't work. For the life of me, I cannot figure out how to make the new 722 work with my old UHF remote. Can anyone help please? I called Dish and they were pathetic.

My thanks.

Oh, the new 722 is in single mode. It's only hooked up to one LCD.

[MrC]

Get into the System Info screen (front panel, or other remote).
Press Record on the old UHF remote.

The 722 should then set the UHF address to the old remote's address.