jimirb
09-22-09, 11:41 AM
Just returned home from a 10 day RV trip with my H20-100. When I hooked it back up at home I did the "repeat satellite setup" for the SL5 dish at home but had no signal on any channel. Did a RBR and all was OK.
Then I turned on the H20-100 that stayed at home (connected but turned off) and it was "searching for satellite 771" on all channels. Did a RBR and it was OK.
I don't understand why both receivers needed a reset when one had been home and turned off and the other had been traveling and used just a few hours before.
The home system is a Slimline 5 LNB thru a Zinwell 6 x 8 multi-switch left over from the days when locals were on the 72.5.
Anyone have any thoughts??
Then I turned on the H20-100 that stayed at home (connected but turned off) and it was "searching for satellite 771" on all channels. Did a RBR and it was OK.
I don't understand why both receivers needed a reset when one had been home and turned off and the other had been traveling and used just a few hours before.
The home system is a Slimline 5 LNB thru a Zinwell 6 x 8 multi-switch left over from the days when locals were on the 72.5.
Anyone have any thoughts??