View Full Version : Any reason for diplexer
chefwong
01-08-10, 05:26 PM
I'm just doing some cleanup....$$ old Spaun switches, etc. Boy, those were the days.
Do you guys see in what application just short of a MOCA network - any use for diplexers ? I used to use them when I carried OTA / DTV over a single coaxial. Have not used OTA forever...Pretty much straight DTV feed. SWM switch - single run to each receiver.
Just debating what I'm going to do with these $$$ Channel Vision diplexers & or if I will ever need them again.
BattleZone
01-08-10, 06:42 PM
If you won't use them, put them up on eBay. Otherwise, hold on to them, because you never know if they'll come in handy. They're small enough...
JeffBowser
01-09-10, 06:58 AM
Likewise here - ton of diplexers, signal lockers, multi-switches, a 5LNB. All obsoleted when I went SWMLine. Need a buy\sell forum up here.
Never mind, there is one, never noticed that before.
tech24218
01-20-10, 09:07 AM
you can use a power passing splitter in a swm application instead of a power inserter. We have been going through hell lately to get the appropriate equipment to get our jobs done. swm power inserters have been hard to find.
veryoldschool
01-20-10, 09:10 AM
you can use a power passing splitter in a swm application instead of a power inserter. We have been going through hell lately to get the appropriate equipment to get our jobs done. swm power inserters have been hard to find.
:confused:
All SWMs [LNB or module] need a PI.
No one should try to power them off a receiver. :nono:
AntAltMike
01-21-10, 04:17 PM
:confused:
All SWMs [LNB or module] need a PI.
No one should try to power them off a receiver. :nono:
I think (hope?) he means that you can use a splitter that passes power on one leg to enable the PI to source the SWM.
veryoldschool
01-21-10, 04:23 PM
I think (hope?) he means that you can use a splitter that passes power on one leg to enable the PI to source the SWM.
I'm afraid that would be a stretch, because of the mention of PIs being hard to come by.
AntAltMike
01-21-10, 04:30 PM
I'd think you could use any old 21-24 volt, 2+ amp power source. I've bought lots of 2 to 3.5 amp, 15 to 18 volt laptop switching power supplies on eBay for under $20 each for all kinds of purposes.
vBulletin® v3.7.6, Copyright ©2000-2012, Jelsoft Enterprises Ltd.