rc64r remote with h23

[nightrider]

i am having problems here , i just went out and bought my rc64r so i can use it upstairs now i can't use another remote to turn the channels downstairs i have a rc64 and rc24 but its a no go

[longrider]

When using RF you must have all RF remotes. You need another RC64R to keep downstairs.

[nightrider]

ok thanks ,, 1 more question , why doesn't this work with the powermid x10 i have a dish net reciever with an ir remote and it changes good upstairs , my directv will not work with the powermid , please help

[mcnallc1]

Did you try it before you set up your H23 to work RF? Once the box is set up for RF it will not respond to IR.

I have used similar products with no problems.

[Edmund]

http://www.dbstalk.com/showthread.php?t=171853

[nightrider]

yes i tried it , if i do a complete reset will it start over so i can try it again, if not i will buy another rc64r remote for downstairs , thanks

[nightrider]

ok i went out and purchased a second rc64r for downstairs it will not work downstairs the rf remote works upstairs anyone no how to activate the second rf remoe to work downstairs thankst

[Edmund]

With receiver and one of the RF remotes n RF mode, set thm aside and do the following on the second RF remote:

1. dtv
2. press and hold MUTE & SELECT, wait for two blinks, release
3. enter 0 0 0 0 1

4. press and hold MUTE& SELECT, wait for two blinks, release
5. enter 9 6 1
6. press CH UP
7. enter the last 6 digits of the Receiver ID #(RID), found on a sticker in the access card compartment
8. press SELECT

[nightrider]

thanks a million for all your help