Cant find SAT C???? Directv

[chastulsa]

Any suggestions finding SAT C? I have a tripple LNB intergrated. I switched out LNB's, I ran a line staright from the Dish to the receiver and all I find is A and B. I get all the core programming Off A (101) but NO channel 99 or 400. C wont align. I adjusted elevation, az, and tilt I locked on tild and elevation when I had full strength on A and B. How is this possible with C being the center LNB?? I thought maybe I had A as A and B as C and no B locked so I scanned left to right and couldnt find tilt? I replaced a Dish and used the courrent pole. I didnt check to see if the Pole was leveled does it matter much? Any suggestions????

-CHas

[SSW_Exposure]

Sounds like your RCVR is set-up to use a 2-LNB oval dish, and not a 3-LNB oval.
Depending on make/model of RCVR, you should find this option in 'Dish Pointing' or 'Installation' then something like dish 'Set-up'

[boba]

Also you must have a sat"C" kit check that you have the sat"C" connected to the correct terminal (satB 18V).

[jdspencer]

He stated that he has the integrated triple LNB dish. I agree that the receiver probably hasn't been set up as using all three LNBs, just two. If he has the older style oval dish and has the Sat C connected incorrectly, then I think he'd show other problems as well.

[SSW_Exposure]

:righton: :dance: