Bug Report 180: Weekly timers not firing

[pculley]

Last night (Wednesday 4/21) I took a few minutes before my favorite shows (about 6:45pm) to look at the timers that were set; I had weekly timers set for two shows on Sat channels at 7:00-8:00pm and 8:00-9:00pm.

In the PVR timer list, these timers were not listed as operative for 4/21 but for 4/28. I Thought that this was odd, but decided to wait and see if they fired. They did not.

These timers have been set since before 180 and not edited. They originally had the padding present, if that makes any difference. The timers had been working correctly for some time prior to 180.

[David_Levin]

Probably would be a good idea to delete the recreate the timers.

[Mark Lamutt]

All of my pre-L180 satellite timers have fired correctly, but as David said, it might be a good idea to set them up again.

[SimpleSimon]

Sounds like what I ran into before Mark reminded me to do a hard reboot AFTER the L180 install reboot.

[srrobinson2]

Last night (Wednesday 4/21) I took a few minutes before my favorite shows (about 6:45pm) to look at the timers that were set; I had weekly timers set for two shows on Sat channels at 7:00-8:00pm and 8:00-9:00pm.

In the PVR timer list, these timers were not listed as operative for 4/21 but for 4/28. I Thought that this was odd, but decided to wait and see if they fired. They did not.

These timers have been set since before 180 and not edited. They originally had the padding present, if that makes any difference. The timers had been working correctly for some time prior to 180.

Mine all continued to work correctly after L180 installed, but I did perform the "pull the plug" reboot after the install completed. Actually, since L180 came down, the OTA and sat recordings have both been much more reliable.