help!!!!!

[shagg7432]

ive installed hundreds and i mean hundreds of 105 supers and i cant make this one work 119 good 110 good 105 good but after replacing every piece of hardware twice the locals pixalate to the point of acquiring signal seriously ive talked to advanced no help even had other techs check the system no cure to date got answers im listening and if dish reads this whats your input !

[Mark Lamutt]

Have you tried a different receiver? 2 or 3 different receivers? There was a story from a user on here about 2 dead receivers not working with a SD installation, and then the 3rd one did work. Other than that, I have no idea...

[homeskillet]

That might have been me Mark, but what happened was my SuperDISH got warped somehow and they actually had to replace the actual Dish. Nobody could really explain "WHY" the superdish warped 3 months after install... but they changed 3 recievers, all the hardware, cabling ect. The last thing they did was change the dish and it worked. Maybe that will help?

[larrystotler]

Sounds like that might be MickDogs problem as well. However, since the thread strater did not bother to give us a signal strength, we can't do too much for them. :(

[Jacob S]

I have also had some experiences with some older 301's not working right with 105 but fine with 110 and 119. I have not messed with the legacy receivers with the adaptor that much to really know if there are issues with that and the SuperDish at 105.

[shagg7432]

the 105 signal is 53 i have replaced the reflector and i r/a 2 receivers

[larrystotler]

53 is way too low for a good signal lock. If that is the best you can get, you will constantly have problems. Try fine-tuning the 105 without worrying about the 110/119. I used a 40x30" P* dish a few eeks ago, and pulled an 80+, but this was with a legacy setup. A bigger dish would help out a great deal to say the least.

[shagg7432]

in my area we use transponder 23 ive seen a max of 60 on it

[shagg7432]

how about back ground interference theres an ac duct 4 ' behind and a window ?

[SimpleSimon]

... I used a 40x30" P* dish a few eeks ago, and pulled an 80+, ...Yes - getting a good signal on 105 sure does seem to take a few eeks. :eek: :eek2:
:p :rolleyes: :D

[larrystotler]

in my area we use transponder 23 ive seen a max of 60 on it

That's probably the problem then. Can you fine tune it any? Because even if you get a picture, if will go out anytime the clouds pass over you.... :D

Simon - The only thing that "eeks" me is MickDog...... :(

[SimpleSimon]

... Simon - The only thing that "eeks" me is MickDog...... :( :D :lol:

[Mickdog]

Dish said the LNB on mine could have went bad. Anyway, they will send a tech, if course not till november, but then, I'll let you all know for sure!!! So :eek2: :eek2: :eek2: :eek2: :eek2: :eek2: :eek2: :eek2: :eek2: