95w Setup

[knightflt]

I have a D10 one dish set to 101 and the other to 95w with a 4X4 multi switch located Sat's with blackbird ran switch check identifies both Sat's an the switch but receiver will not let me go past the three digit channels I need to be able to get up in the four digit channels. Whats up brand new D10 receiver.
Any help would be appreciated...

[Crystal Pepsi Ball]

You have to run an auto detection thru the menus to have it detect the 95 sat location.

[knightflt]

Yes it does pick up the 101 and 95w Sat's and the 4x4 switch in the auto detect but cannot get up into the higher channels 2000 and above I have tryed more than one receiver (D10) but same thing.

[Newshawk]

4x4 switch? I thought that a setup with a 95 (or 72.5) dish had to have a multiswitch with a flex port... Perhaps that is your problem, especially since the 95 sat, IIRC, is vertically polarized instead of circularly polarized.

[knightflt]

only have to use flex port on a 6x8 multi switch I am detecting both dishes 101 and 95 in the auto detect I think maybe it is the receiver software version that may be the problem I have attached the setup diagram for switch needed

[2devnull]

Did you get this issue resolved with the 4x4 switch and able to get 95 and 101 using international dish? Thank you.