Lost video on Auxiliary input

[langlin]

I have lost video on Auxiliary input, audio in OK, Video flashes on when you first go to it then goes off. It also flashes on as you leave the aux input. Anyone else use Aux input and is it still OK? I'm wondering if it is just my 921 and not an issue for all? :confused:

[Mark Lamutt]

Did you check your cable connected to the AUX in on your 921? That sounds to me like your video cable has been knocked loose.

[Jason Kragt]

I have also had problems with my "channel 0" input. A reboot seems to fix it.

[langlin]

It is not my cables or that they are loose, but I have found today that it sometimes will switch to "0" OK and stay and other times it only has video momentarily.

[Cyclone]

I found that if I just turn the 921 off and then back on, that I will get my pic on aux 0. This used to work all the time, but it broke with a release earlier in the year. I posted a thread about it, but I got little feedback.

[langlin]

Thanks for the tip Cyclone, turning the 921 off and on restores my Aux video every time so it is a bug. I will put it on Allen's bug thread.

[sjm992]

It is not my cables or that they are loose, but I have found today that it sometimes will switch to "0" OK and stay and other times it only has video momentarily.

I found that it will switch to channel '0' OK if the previous channel that I was viewing was SD (this works every time). However, if the previous channel was HD, it fails, sometimes with, as someone mentioned earlier in the thread, a very brief flash from '0'. Same applies if I was watching a recorded program. Switching the 921 off then on again with the remote brings back '0'.

Could someone else try to confirm my results please.
Stuart

[langlin]

Stuart, I tried to test your theory on HD vs SD but for some odd reason my 921 has decided to work correctly, now it will correctly switch to "0" from either HD or SD and I can't get it to fail, but if (when) it does in the future, I'll try your idea and let you know.