DirecTv SAT T60 question

[jyurciw]

:confused: Last week I just got my new MPEG4 5LNB dish installed for my H20, very happy with the install and it works great, getting the locals in HD from Wash. DC. While the installer was here, I had him install a multiswitch (Zinwell WB68)so that I could get the D* signal through out my house. My problem now is I want to install a SAT T60 in one of the rooms in my house but I only have a single outlet going to that room and I want to make use of the dual tuners in the the receiver. Is there some sort of splitter or something that I can use so that I can connect the 2 tuners from the single cable feed?:confused:

Thanks in advance for the help.

Should of had the installer do this when he was here but it was an afterthough

[CCarncross]

No. YOu need a second independent line from the multiswitch to that room, as all dual tuner D* receivers need....unless you dont mind spending a few hundred for a stacker/destacker setup....most just buck up and run the cable they should have run in the 1st place..

;)

[ADent]

You can put the SAT T60 near the Zinswell and run the output of the T60 on the single coax.

IR over coax works pretty well to control it.