kruegs
02-19-07, 10:12 AM
Hello all... long time lurker, first time poster. I have a Slimeline ODU which was installed about a month ago. Unfortnately the weather was horrible when the installer was here and he did not use the two small screws which hold the LNB on to the mast for whatever reason. I asked him about it as he was finishing up and he said at the time that they were not required because of the already tight fit.
The snow has finally subsided enough for me to take a closer look at his work this past weekend. Everything looks great, expect those two screw holes still bother me. In all likelyhood it will probably be fine, but I would prefer to just get some screws and fix it up myself. Of course the install was long enough now that my chances of getting him back out to fix it are slim to none.
Does anyone know the size for the screws? My dish is on my roof and doing the trial and error method to get the correct size is going to be difficult at best.
Thanks much!
Mike
The snow has finally subsided enough for me to take a closer look at his work this past weekend. Everything looks great, expect those two screw holes still bother me. In all likelyhood it will probably be fine, but I would prefer to just get some screws and fix it up myself. Of course the install was long enough now that my chances of getting him back out to fix it are slim to none.
Does anyone know the size for the screws? My dish is on my roof and doing the trial and error method to get the correct size is going to be difficult at best.
Thanks much!
Mike