DBSTalk Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-9 of 9 Results
  1. DIRECTV Installation/MDU Discussion
    Yep , you guys were right. Changed out the SWM and everything came back up. Never heard of an LNB going out after 6 months , but guess it happens. Thanks for all the help!
  2. DIRECTV Installation/MDU Discussion
    Tried resetting the SWM. Unplugged all receivers and power inserter. Plugged everything back in. Still the same problem. Not sure what else I should try.
  3. DIRECTV Installation/MDU Discussion
    My folks have a SWM system with 3 receivers that was installed by Directv about six months ago. Everything has been fine until yesterday. They called me and said there satelite went out. I went over and checked there signal meters and they have 90 percent signal on 103. But no signal on 99 , 101...
  4. DIRECTV General Discussion
    I have already handled the Commercial fee. ( $ 1199.00 for Sunday ticket with a seating capacity of 50-100 ouch!!! ) You can have up to 20 receivers on that plan. Just looking for the best way to set it up Thanks
  5. DIRECTV General Discussion
    Just one HD tv , will be the only one that the sound is used on. Will probably have 10 other TV's to feed , a couple of them can be duplicate feeds. I will also have an antenna for OTA digital feeds. Maybe I'm wrong but I swear some of the sports bars I have been in use some sort of modulator...
  6. DIRECTV General Discussion
    I am planning on installing a multiple receiver setup in my bar for Sunday ticket and Gameplan. Any suggestions on the best way to wire this? I plan on a triple lnb dish , maybe one HD receiver , and about 5-6 additional cheap receivers. Any tricks on setting this up? Any help would be...
  7. General DISH™ Discussion
    The 105 signal averages around 55-60. I am banging my head against the wall trying to figure this out. Driving me crazy. I went up and unhooked everything from the dp34 switch again and reconnected the 105 straight through the 1 port again , just to reset everything. Again the " congratulations...
  8. General DISH™ Discussion
    Thanks for the replies. I do have a dp34 switch that came with the superdish. After running the check switch ( 3 test ) when I hit the details button it shows odd/even for polarity on each sat. Still can't figure out why channel 7000 is gone also? It was there before I ran the program guide...
  9. General DISH™ Discussion
    I am having a problem getting my 501 to recognize my new superdish. More specifically getting it to bring up my new channels on the guide. I have all three sats ( 105 , 110 , 119 ) locked and recognized. When i first did the dish install , my receiver came on and said " congradulations , you...
1-9 of 9 Results
Top