1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

3D on HR-34 problem

Discussion in 'DIRECTV HD DVR/Receiver Discussion' started by jimrobinette, Oct 19, 2012.

  1. jimrobinette

    jimrobinette AllStar

    61
    0
    Aug 31, 2007
    Brand new HR-34. HR-34->Onkyo Receiver->Panny TV. The 3D channels in the guide show up as greyed out, as in not available to me. The DirecTV installer said I need to connect it directly to the TV to get 3D. Well, the HR-24 that I unplugged and plugged the HR-34 into the same coax and HDMI worked great through the receiver for 3D. I literally just swapped the boxes, and now the HR-34 doesn't see my Panny as 3D capable, even though I've been watching 3D for a year with an HR-24 on it.

    Any ideas?
     
  2. ohioviper

    ohioviper AllStar

    73
    0
    Sep 18, 2007
    Same problem on my Onkyo HT-S5500 with HR-34.
     
  3. FHSPSU67

    FHSPSU67 CE'er & Retired Engineer DBSTalk Club

    2,592
    41
    Jan 12, 2007
    Windber, PA
    The only advice I can give is to power up the TV and AVR before powering up the HR34. Not a perfect solution, but I've found it to work the best of anything else.
     
  4. dsm

    dsm Godfather

    319
    2
    Jul 11, 2004
    Same problem here. If I switch my denon receiver to PS3 and back to the HR34 it will show up. As the other poster said though, power up order and timing matters. The Harmony One remote I have is very powerful, but it is annoyingly difficult to get this right with one button startup. I tried for about an hour to get the stupid remote to do it automatically and couldn't do it. So I just switch inputs when it's greyed.
     
  5. Beerstalker

    Beerstalker Hall Of Fame

    3,488
    64
    Feb 9, 2009
    Peoria, IL
    Shouldn't be that hard to get the Harmony to work. There is a section where you can tell it what order to turn the devices on so you can change that. I'm pretty sure you can also add in a delay in between powering the devices on, but you might have to call tech support to get that added. It's been a while since I've had to mess with programming any of my Harmonys.
     

Share This Page