1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

712-Quad LNB Tech Bulletin

Discussion in 'General DISH™ Discussion' started by Haywood, Aug 10, 2002.

Thread Status:
Not open for further replies.
  1. Haywood

    Haywood Cool Member

    14
    0
    Jun 26, 2002
    Got this from Dish, figured I'd pass it along here:


    Subject: Quad LNBF – Special Installation Instructions for the DishPVR 721
    Products Affected: DishPro Quad LNBF, DishPVR 721
    Purpose:
    This bulletin provides special instructions for installing the DishPro Quad LNBF with the DishPVR 721 receiver.
    Instructions:
    The DishPVR 721 receiver must take a software upgrade (L100 or later) from the satellite before it will work with the DishPro Quad LNBF.
    While there are instances when a DishPVR 721 receiver will take an initial software upgrade through a DishPro Quad LNBF, it is not consistent and therefore not the recommended method. The initial software should be upgraded through an LNBF other than a DishPro Quad LNBF using instructions from the DishPVR 721 User’s Guide. It is recommended that a software upgrade from the satellite be accomplished at the dealer’s shop to enable the DishPVR 721 to be installed at the customer’s location with a DishPro Quad LNBF.
    Software in DishPVR 721s from later production runs will be updated to include DishPro Quad LNBF installation support.
     
  2. Jacob S

    Jacob S Hall Of Fame

    7,657
    0
    Apr 14, 2002
    It sounds to me like there has been a slew of problems with lnbf's and the issues with them. twin not working on 301, 501, dishpro not working with 721, now quad on 721, does anything work that do not have external switches with built in switch like twin and quads? Is there an issue with quad with 301, 501? Is there an issue with dishpro with 301, 501?
     
  3. Lyle_JP

    Lyle_JP Icon

    844
    0
    Apr 22, 2002
    It's important to point out that these problems are occuring with the DishPro Twins and Quads. As the owner of an older standard Twin, I've experienced none of these issues.

    I think there are still a few bugs to be worked out in the DishPro switches.

    -Lyle J.P.
     
  4. mnassour

    mnassour Icon

    859
    9
    Apr 23, 2002
    Geez....technical innovation is nice and to be encouraged, but has Dish ever had a single, major, introduction that didn't have a fatal bug in it?
     
  5. Jacob S

    Jacob S Hall Of Fame

    7,657
    0
    Apr 14, 2002
    So, is this the actual twin and the switch inside or is it the software like I have been told and thought it was?
     
Thread Status:
Not open for further replies.

Share This Page