Hey everyone, I am trying to set-up a 7200 with a DPP44 switch. I have two other receivers (942, 811) and the switch works fine for them, but when I try to get the 7200 to see the switch, I get "no switch box detected". I have three orbital slots that are hooked up to the DPP44. Port 1: 119, Port 2: 110, and Port 3: 61.5. I have my 942 connected to the Receiver '1' output along with the power inserter. 811 to Receiver '2' output and 7200 to Receiver '3' output. I have even tried swapping the outputs around, but still doesn't work. Could this possibly be my problem? I have a Dish Pro Plus Twin LNBF for the 119&110 slot and I have a Dish Pro Twin for the 61.5 slot. (Obviously, I'm using only one of the connections for this). I thought that you could use either Disp Pro and/or Dish Pro Plus with the DPP44. Any help with this would be greatly appreciated!!! Thanks!