1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

caller ID

Discussion in 'ViP612/622/722/722K DVR Support Forum' started by drm2869, Mar 1, 2007.

Thread Status:
Not open for further replies.
  1. drm2869

    drm2869 Cool Member

    18
    0
    Nov 14, 2006
    Had the 622 installed yesterday and all is great except the caller ID is not working. I am using a wireless phone jack which the tech said is working fine during the setup process of the 622. I just ran a diagnostic test it shows the phone connection is ok. I have caller ID enabled but still nothing shows up on the TV. any ideas?
    Thanks
     
  2. ChuckA

    ChuckA Hall Of Fame

    2,010
    0
    Feb 7, 2006
    What brand is your wireless jack? Some of them do not support CID. Check the specs on yours to see if it says it specifically supports CID.
     
  3. drm2869

    drm2869 Cool Member

    18
    0
    Nov 14, 2006
    I have a Radio Shack now and it is about 7 or 8 years old. It worked great with my 2700 and then my 721 receiver.

    Does anyone know of a specific model of wireless phone jack that does support caller ID?
     
  4. ndyclrk

    ndyclrk AllStar

    56
    0
    Jun 5, 2006
    Phonex PX441/442 is supported. RCA RC930 is the same model rebranded.
     
  5. ChuckA

    ChuckA Hall Of Fame

    2,010
    0
    Feb 7, 2006
    I use the RCA RC930 and CID works fine with it.
     
Thread Status:
Not open for further replies.

Share This Page