1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CCK can't connect to my comcast router

Discussion in 'DIRECTV Tips and Resources' started by tomasmk2003, Aug 19, 2012.

  1. doolittle.dtv.iss

    doolittle.dtv.iss Cool Member

    18
    0
    Aug 19, 2012
    The wifi stands up. Also has more lights on it. And yes it would need the deca.
     
  2. Laxguy

    Laxguy Honi Soit Qui Mal Y Pense.

    15,345
    578
    Dec 2, 2010
    Winters,...
    Where was it determined that it was a DNS issue?
    It could be an IP address issue, and the router's range of numbers may not begin with 208.
     
  3. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    While it can be done with a "simple" cable, the WCCK is for homes that need WiFi, since powerline adapters have [thankfully] gone away.
     
  4. banditt76

    banditt76 Godfather

    266
    0
    Jul 17, 2012
    I'm trademarking that now and using it in my interior design magazine for tech weekly :p
     
  5. doolittle.dtv.iss

    doolittle.dtv.iss Cool Member

    18
    0
    Aug 19, 2012
    And I will post all wifi installation stuff I have in morning.
     
  6. Laxguy

    Laxguy Honi Soit Qui Mal Y Pense.

    15,345
    578
    Dec 2, 2010
    Winters,...
    !Devil_lol
     
  7. banditt76

    banditt76 Godfather

    266
    0
    Jul 17, 2012
    Oh OK...I have had wifi forever and just assume everyone else does by now. Most ISP's have wireless built into their modems now.
     
  8. doolittle.dtv.iss

    doolittle.dtv.iss Cool Member

    18
    0
    Aug 19, 2012
    Error 22 is a Dns error. 13 is local ip. No physical Ethernet. Check connections test again.
     
  9. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    I think you're missing what's going on here:

    One HR21 that needs a WiFi connection for internet.

    The WCCK can and should be connected to the HR21 ethernet and that's it.

    The coax shouldn't run through the WCCK either or the SAT feed will have problems with the DECA signal.

    This comes straight out of the WCCK manual and how it should be:

    [​IMG]
     
  10. banditt76

    banditt76 Godfather

    266
    0
    Jul 17, 2012
    I've been at this thread since the beginning almost. There is an IP conflict at 10.0.0.10 and error 22 on the CCK or receiver, I forget which. Someone here said 22 means DNS issue on whatever device gave that error. I assumed it was the receiver since it is the only one with a display connected to it.
     
  11. tomasmk2003

    tomasmk2003 Mentor

    32
    0
    Aug 19, 2012
    Okay here's a few pictures
     

    Attached Files:

  12. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    Let me see how many others I can get to join in here and we can really screw the OP up. !rolling
     
  13. Kaiser Bob

    Kaiser Bob Cool Member

    48
    2
    Aug 17, 2012
    Ok, so theres coax running to the CCK-W so that suggests you have a receiver DECA too or something's not hooked up right. Is the ethernet cable going from the receiver to the CCK-W or the black rectangular as yet unidentified box?
     
  14. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    If this is a one HR21 receiver setup, without another receiver, then you should seriously rewire this to the configuration posted just above.
    You shouldn't have the coax run through the WCCK, nor have the black DECA connected to your HR21.
    Take the ethernet cable from the WCCK and run it to the HR21.
     
  15. doolittle.dtv.iss

    doolittle.dtv.iss Cool Member

    18
    0
    Aug 19, 2012
    The only time ethernet touches the back of the ird from the back of cck- w is when it is a ka/ku install. Otherwise coaxial comes from the lnb thru The cckw and then to reciever with no Ethernet cable. This would hypothetically disable Mrv if it applied and cckw would have missing lights. And this is a fact.
     
  16. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    This looks like another installer who had his head up.... [where he shouldn't].

    HR21 to DECA to WCCK to router, but should be:

    HR21 [ethernet[ to WCCK, that DOESN'T have the coax connected to it.
     
  17. Kaiser Bob

    Kaiser Bob Cool Member

    48
    2
    Aug 17, 2012
    I agree with this suggestion.
     
  18. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,683
    348
    Dec 9, 2006
    You are correct but not for this case.
    This isn't a H/HR24, so there is no internal DECA to disable, nor does it have MRV, since it's a single HR21 install.

    This install "merely" needs the WCCK to connect the HR21 ethernet port to the WiFi router.
     
  19. tomasmk2003

    tomasmk2003 Mentor

    32
    0
    Aug 19, 2012
    Ethernet is running from the unknown device to the dvr
     
  20. banditt76

    banditt76 Godfather

    266
    0
    Jul 17, 2012
    This thread is hilarious. I bet we are taxing the DBSTalk server. The New Posts link can't even keep up. :p
     

Share This Page