1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

dvr 625

Discussion in 'Standard Definition Receiver Support Forum' started by mjpeach, Feb 17, 2006.

Thread Status:
Not open for further replies.
  1. mjpeach

    mjpeach New Member

    1
    0
    Feb 13, 2006
    if i run the tv2 to all the tvs in the house via the wall jacks. (running though the splitter not the closes wall jack)can i get satellite singal on all them, or would that work (I know you can only watch two channels at once)
     
  2. LtMunst

    LtMunst Hall Of Fame

    1,267
    3
    Aug 24, 2005
    You can run the TV2 output to as many tvs as you want. With alot of splits, though, you may end up needing to get a signal amplifier. Usually 2-3 splits is ok. Any more than that and you'll need an amp ($29.00 at RadioShack).
     
  3. phat_b

    phat_b Legend

    103
    0
    Apr 19, 2005
    I'm piping mine through a 4-way splitter and then a 2-way that's connected through a diplexer and even those last two sets have quite acceptable picture quality. YMMV.
     
  4. bnewt

    bnewt Godfather

    398
    5
    Oct 2, 2003
    This signal is stereo, correct?
     
  5. greatwhitenorth

    greatwhitenorth Godfather

    360
    0
    Jul 18, 2005
    Yes, the TV2 output is in stereo.
     
  6. bnewt

    bnewt Godfather

    398
    5
    Oct 2, 2003
    What about any noise with these receivers? Are they as quiet as the 508?
     
  7. jwest

    jwest New Member

    9
    0
    Jan 21, 2006
    It's pretty quiet. The fan turns on every now and again, but I can barely hear it from where I sit (~10ft away).
     
Thread Status:
Not open for further replies.

Share This Page