1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Endless switch of 'Aquiring Signal' and 'Downloading guide' screens on a VIP612 DVR

Discussion in 'ViP612/622/722/722K DVR Support Forum' started by SpasticTech, Aug 23, 2013.

  1. SpasticTech

    SpasticTech New Member

    1
    0
    Aug 23, 2013
    NC
    This post isnt a question to a technical problem I have, but it is a possible fix to the VIP612 or other VIP receivers supplied by Dish.

    I too had the endless loop problem that alternated between 'Aquiring Signal' and 'Downloading Guide', would get 20 second of TV if I was lucky, then the loop would start all over. After checking connections, using '6-1-1' to check switches, defaulting the settings. . .ect ect. . .I called tech support and the person I talked to had no clue on what was going on. This techs solution was to send us a replacement unit, which would take 5 days to recieve.

    Hmmmmmm. That really ticked me off. I'm pretty savy with tech, so I busied myself checking everything over again (my wife wouldn't be able to endure 5 days of her drama TV . . . >(8 ] . . .) Now we have internet connected into our DVR for the 'On-Demand' streaming features, so I started wondering if there was a conflict somewhere. My wife had told me she had streamed a few movies the previous day and had stopped one in the middle because it was a horrible movie. That night the guide went to update, and WHAM. We were stuck in the endless loop.

    Here is the fix. It is as simple as removing the patch cord from the DVR to the modem. Instantly the guide updated, and the Sat feed came right back. No problems. Re-inserted the patch from the modem, and finished updating the movie list.

    Before you folks go into soft reboots, hard reboots, switch checking, splitter tightness, grounding. . .blah-de-blah blah. . . and ultimately pulling your hair out because you will be without service for a number of days, give this a try. Quick, easy, takes 2 minutes.
     
  2. P Smith

    P Smith Mr. FixAnything

    21,320
    127
    Jul 25, 2002
    Mediterranea...
    Would be interesting if the hint will works for all ViP models and all FW versions.
    BTW, you forgot mention your DVR FW version.
     
  3. Stewart Vernon

    Stewart Vernon Leapin' Lizard Staff Member Super Moderator DBSTalk Club

    21,436
    358
    Jan 7, 2005
    Kittrell, NC
    The 922 had an infinite reboot issue once, a year or so ago, and I remember the fix being to disconnect ethernet. They fixed it at some point with a firmware update... but now you have me wondering if this could have been related to that problem... and IF so, if they fixed it on the 922 maybe they could fix it on other receivers.
     

Share This Page