1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Has anyone used an attenuator with DisEQC switch?

Discussion in 'General Satellite Discussion' started by vrushali, Aug 4, 2007.

Thread Status:
Not open for further replies.
  1. vrushali

    vrushali New Member

    3
    0
    May 11, 2007
    Hello,

    In my setup, I have 3 LNBs feeding into a DisEQC switch. The setup works almost fine. I can switch from SAT A to SAT B or SAT C. I can also switch from SAT B to SAT A or SAT C. However, once I am on SAT C, switching does not work anymore. I just get locked into SAT C.

    Someone suggested to me that the LNB on SAT C is drawing lot of power. Hence, the DisEQC is not able to switch. This person also suggested that I insert a 10 Db Attenuator between the LNB and the DisEQC switch.

    I am wondering if anyone had a similar problem and was solved using the attenuator.

    Thank you in advance for your help.

    Vrushali
     
  2. P Smith

    P Smith Mr. FixAnything

    21,627
    144
    Jul 25, 2002
    W.Mdtrn Sea
    The person is just ... a person; his advise is wrong.
    Not sure if you could make some soldering works in that switch, so just buy new one - it's cheap.
     
  3. FTA Michael

    FTA Michael Hall Of Fame

    3,474
    4
    Jul 21, 2002
    I had a similar problem like that once. My answer was to swap the faulty LNB. :D
     
Thread Status:
Not open for further replies.

Share This Page