1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Help with installation

Discussion in 'FTA / Non Small Dish Satellite Area' started by harryjaswal, May 30, 2012.

  1. harryjaswal

    harryjaswal New Member

    8
    0
    May 23, 2012
    n someone help me with dish installation please and some information as well please about NSS 6 95 E
     
  2. samrs

    samrs MANC DBSTalk Club

    1,511
    26
    May 30, 2004
    Flat Branch, NC
  3. harryjaswal

    harryjaswal New Member

    8
    0
    May 23, 2012
    Hi samrs,
    Can you please tell me what is azimuth as in the attached picture and what's skew for LNB and how to set it up please.
     

    Attached Files:

  4. harryjaswal

    harryjaswal New Member

    8
    0
    May 23, 2012
    And it's showing a blocking point I guess, so is it means I can't get the signal????????
     

    Attached Files:

  5. analogqueen

    analogqueen New Member

    1
    0
    Jun 5, 2013
    Hot, Dry,...
    Not necessarily, Harry. Do you have a clear line of sight to the satellite? Where I am it also shows a "block" of a building that is in line with the satellite, but from my elevation and the actual laser sight (if I were to use one that is) I have a direct line TO the satellite I am trying to receive.

    You came in just asking "can someone help me with my installation" did you even install the dish to the pole, or anything yet? Have you installed it and made sure the pole was PLUMB, in other words NOT tilted or skewed- used a spirit level to make sure it's exactly level? How far have you gotten with it so far?

    Have you installed it in a professional manner and are unable to receive any signal to the receiver? Please be more specific.
     

Share This Page