1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How good is the Super Home Node for OTA antenna?

Discussion in 'DISH™ OTA Support and Discussion Forum' started by tpcshadow, Jun 30, 2008.

  1. tpcshadow

    tpcshadow New Member

    5
    0
    Jun 24, 2008
    I would like to use the Super Home Node to combine the outputs of a dual tuner model with an OTA antenna like the attached image. Is the SHN a good option? Or would it be better to go with discreet components (preamp, combiner, splitter)?
     

    Attached Files:

    • shn.jpg
      shn.jpg
      File size:
      62.6 KB
      Views:
      492
  2. rodent

    rodent New Member

    9
    0
    Aug 21, 2006
    I currently use the SHN to combine the modulated channel 69 output of my ViP622 DVR for TV2, along with an OTA antenna and get great results, although I had to buy a low-pass filter to keep the amplified antenna from disturbing channel 69.

    The low pass filter that I bought was from Solid Signal, the ChannelMaster LPF-750, solidsignal.com/prod_display.asp?prod=CPLPF-750 - it passes off-air channels 2-60 (CATV channels 2-116). It does not pass TV 65-69 (CATV 121-125) so you can insert your TV2 output using one of those channels and it should be pretty clear.

    Without the low-pass filter, regardless of which modulated channel I chose for TV2 output, it was snowy and grainy on the TV2 TVs after it passed through the SHN. If I unplugged the antenna feed from the SHN, then the picture would improve, so I knew it was the antenna. I was originally under the impression that the SHN had some kind of low-pass filter built in and would make room for the modulated TV2 signal, but that wasn't the case. I am wondering now that depending on how many TVs you need, you might not even need a super home node. Just get a 2-way splitter/combiner and combine the TV2 and antenna feed (put the low pass filter on the antenna line before the splitter/combiner or SHN) and then send that combined feed to a splitter for distribution to the TVs. I'm sure there'd be some signal loss but it might be acceptable. I'm not sure if this would broadcast your TV2 output over your antenna, though the low-pass filter would probably stop it since it doesn't pass channels
     

Share This Page