1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

HR10-250 w Mitsubishi Component Inputs Question

Discussion in 'DIRECTV HD DVR/Receiver Discussion' started by bullitt, Aug 11, 2004.

Thread Status:
Not open for further replies.
  1. bullitt

    bullitt Legend

    152
    2
    Apr 26, 2002
    :confused: If my Mits 55809 component inputs are only 480i and 480p does that mean they are upconverting the signal when I select 1080i?
    The other set of inputs are labeled DTV and accept 1080i but did not seem to work when I first installed and assigned that input as Y,R,Pb so I went to component input. The picture seems fine but I want to make sure I'm getting the correct signal.
     
  2. Shappyss

    Shappyss AllStar

    88
    0
    Jun 26, 2004
    i thought that Y, PR, Pb is component. If your TVs component inputs are only 480 then it will downconvert the 1080i signal
     
  3. bullitt

    bullitt Legend

    152
    2
    Apr 26, 2002
    Sorry, I had a brain dump. I do have DTV selected not component.
     
Thread Status:
Not open for further replies.

Share This Page