1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Installation process for my setup

Discussion in 'General DISH™ Discussion' started by nolow, May 31, 2013.

  1. nolow

    nolow New Member

    5
    0
    May 4, 2012
    I am concerned about how they will run the wires in my home. Through the FAQ's, it appears that receivers only need one coaxial cable. I currently have cable. There is a single coaxial run outside. This goes to a junction box in a closet with a splitter. All of the coxial cables from my rooms run to this central location.

    How many wires have to go to the actual satelite dish?

    I plan on purchasing the Top 120 plan and add international programming. I believe that a second dish is requried for the international programming. Would this require additional coaxial runs?
     
  2. Jim5506

    Jim5506 Hall Of Fame

    3,630
    32
    Jun 7, 2004
    The wing dish can be connected to the input port on the main dish.

    Which system are you getting?

    The Hopper/Joey system only requires one coax from the Dish to the Hopper, then a coax to the node which connects to all your Joeys, so your current setup can work well there, if however youare getting a VIP (722or 211) setup one cable is required from the dish to each receiver.
     

Share This Page