The installer left the receiver in dual mode with record plus enabled on TV 2, this 622 is hooked up to 1 TV with component cables. We sent some stuff to record last night and it choose TV2. We also set a second program to record at the same time as and it chose TV1. well when TV2 said it was recording I didn't see a red light on the receiver. When TV1 started to record the red light showed up on TV1. This morning when I woke up and went to the DVR it's only showing the events recorded on TV1, but when you go to timers it says "done" next to all the recorded stuff on TV2. This is confusing. Shouldn't it be in single mode? Did I loose those recordings somehow? I thought by reading the FAQs and stuff beforehand I would know how to work this thing but I was wrong lol.