1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Invacom LNB questions

Discussion in 'FTA / Non Small Dish Satellite Area' started by Mark40930, Aug 8, 2009.

  1. Mark40930

    Mark40930 Mentor

    48
    0
    Aug 2, 2007
    Las Vegas, NV
    I purchased an Invacom dual linear/circular LNB off of eBay, and plan on using it with a 33 inch dish for FTA. Going to just go stationary to Galaxy 19 for the time being then add the motor later. Receiver is a Pansat 2700A.

    Would I need a DiSecq switch with this LNB to allow it to switch polarization (connecting the LNB to the switch with 2 cables) or will the receiver be able to handle it on its own with single cable connection?
     
  2. PTown

    PTown Legend

    199
    0
    Aug 18, 2007
    If it's stationary at galaxy 19 you only need the linear output anyways, but when you motorize and you want both then yes, you will need a switch and corresponding settings in the receiver.
     
  3. Mark40930

    Mark40930 Mentor

    48
    0
    Aug 2, 2007
    Las Vegas, NV
    Thanks for the info, now I can get things started. :)
     
  4. Mark40930

    Mark40930 Mentor

    48
    0
    Aug 2, 2007
    Las Vegas, NV
    After much trial and error I managed to get my setup going and receiving programming from Galaxy 19. Now just need to get the SG2100 motor and a good sturdy ground mount mast in place.:D
     
  5. sadoun

    sadoun AllStar

    88
    0
    May 28, 2002
    Hi Mark

    How is your motorized dish project prospects going?
     
  6. Mark40930

    Mark40930 Mentor

    48
    0
    Aug 2, 2007
    Las Vegas, NV
    Went very well thank you...I have purchased your Motrek SG-2100 motor online and it is working excellent!
     

Share This Page