1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Lost all Scheduler programming

Discussion in 'DIRECTV General Discussion' started by sperho, Dec 8, 2008.

  1. Dec 8, 2008 #1 of 10
    sperho

    sperho Mentor

    39
    0
    Sep 27, 2008
    Is there any reason why I would have suddenly lost all of my programmed recordings? Yesterday, I had a "Search For Satellite" (721?) issue which after a red button reset, it resolved. I'm receiving signals just fine. I'd really like to get back the 39 settings that I had previously if possible. :confused: :new_cussi Why??

    I have an HR-21-700, no mods, no external drive, and no CE downloads. The last firmware update was the national rollout in November...
     
  2. Dec 8, 2008 #2 of 10
    Greg Alsobrook

    Greg Alsobrook Lifetime Achiever

    10,453
    0
    Apr 1, 2007
    After a reboot, it takes the scheduler a while to rebuild. Check it again in the morning. I bet most, if not all, will be back.. but technically I think it can take up to 24 hours for it to rebuild completely.
     
  3. Dec 8, 2008 #3 of 10
    sperho

    sperho Mentor

    39
    0
    Sep 27, 2008
    Interesting... I've rebooted before and no delay was observed. Is it random?
     
  4. Dec 8, 2008 #4 of 10
    Jeremy W

    Jeremy W Hall Of Fame

    13,447
    0
    Jun 19, 2006
    The Prioritizer doesn't take time to rebuild, the To Do List does. If you're missing stuff from the Prioritizer, it's gone for good.
     
  5. Dec 8, 2008 #5 of 10
    sperho

    sperho Mentor

    39
    0
    Sep 27, 2008
    Prioritizer list is gone. Has anyone every seen this before and know why it happened?
     
  6. Dec 8, 2008 #6 of 10
    Jeremy W

    Jeremy W Hall Of Fame

    13,447
    0
    Jun 19, 2006
    I had it happen before. Turned out I had some corrupted entries, caused by using the Record Series Link option on the remote scheduler.
     
  7. Dec 8, 2008 #7 of 10
    sperho

    sperho Mentor

    39
    0
    Sep 27, 2008
    Sigh. Never used Remote Scheduler.
     
  8. Dec 8, 2008 #8 of 10
    Jeremy W

    Jeremy W Hall Of Fame

    13,447
    0
    Jun 19, 2006
    My guess would still be a corrupt entry. It's unfortunate, and it's a pain. But all you can do is start over at this point.
     
  9. Dec 8, 2008 #9 of 10
    sperho

    sperho Mentor

    39
    0
    Sep 27, 2008
    Any way of backing up a Scheduler/Prioritizer list? (Other than writing it down...)
     
  10. Jeremy W

    Jeremy W Hall Of Fame

    13,447
    0
    Jun 19, 2006
    Nope.
     

Share This Page