1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

not aquiring signal

Discussion in 'Standard Definition Receiver Support Forum' started by rtfltl62, Feb 24, 2012.

  1. rtfltl62

    rtfltl62 New Member

    1
    0
    Feb 24, 2012
    stuck on aquiring signal screen,stays on zero,cant access guide,help how can i reboot ?this reciever is not the main
     
  2. Stewart Vernon

    Stewart Vernon Leapin' Lizard Staff Member Super Moderator DBSTalk Club

    21,451
    358
    Jan 7, 2005
    Kittrell, NC
    What model receiver?
     
  3. gtal98

    gtal98 Godfather

    363
    1
    Jan 30, 2011
    Unplug the power cord for 30 seconds and plug back in. If there are a lot of cords, look for the one with the red flag attached to it.
     
  4. Ray C@DISH Network

    Ray C@DISH Network DISH Representative DISH Representative

    914
    1
    Dec 28, 2010
    Unplugging the receiver from the electrical outlet for 10 seconds causes the receiver to reboot but if you are having signal issues, you will get the acquiring signal message again. After the receiver reboots, it is normal to get the acquiring satellite message. Are you getting the same message on your other receiver? Please let me know. Thanks.

     

Share This Page