1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Phase 3 18x20 dish problem triple feed

Discussion in 'DIRECTV Installation/MDU Discussion' started by 1sandiegoed, Apr 2, 2011.

  1. 1sandiegoed

    1sandiegoed New Member

    2
    0
    Apr 2, 2011
    I can not get a signal from the dish model number AU2-F.
     
  2. carl6

    carl6 Moderator Staff Member DBSTalk Club

    12,435
    929
    Nov 15, 2005
    Seattle, WA
    Not much info to go on here. Has it worked previously? Did you just install or move it? What are you using to test the signal? Providing as much information and detail as you can will greatly help us to offer suggestions.
     
  3. jdspencer

    jdspencer Hall Of Fame

    6,629
    12
    Nov 7, 2003
    That dish centrally aligns to the 110 satellite.
    Check your aiming parameters on http://dishpointer.com

    Make sure the mast is plumb and that the tilt and elevation settings are correct.
    Then adjust the azimuth.
     
  4. joe diamond

    joe diamond Hall Of Fame

    3,071
    0
    Feb 28, 2007
    +

    Select phase III satellite dish and not....NOT...SL3 and not 3LNB SWM.

    +

    Check every fitting.......

    +

    correct input etc.

    More hints at what you are doing and have done would help.

    Joe
     

Share This Page