1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Power Cycle HR20 After Software Upgrade

Discussion in 'DIRECTV HD DVR/Receiver Discussion' started by pete4192, Aug 31, 2007.

Thread Status:
Not open for further replies.
  1. pete4192

    pete4192 Godfather

    276
    0
    May 22, 2007
    After every software upgrade, my HR20 will not boot up. I have to unplug and plug the power cord to get it to boot up. Anyone have any idea why this happens?
     
  2. Tom Robertson

    Tom Robertson Lifetime Achiever DBSTalk Club

    21,331
    247
    Nov 15, 2005
    Is your network connected? There have been some issues (thought to be in the past for most people) with network problems?

    And is your system (dish, coax, multiswitch) all properly grounded?

    Cheers,
    Tom
     
  3. pete4192

    pete4192 Godfather

    276
    0
    May 22, 2007

    I just networked the HR20 last night, so that wasn't the issue. Everything is properly grounded, so I don't think that's the issue either.
    Thanks for the suggestions, though.
     
  4. Stuart Sweet

    Stuart Sweet The Shadow Knows!

    37,060
    287
    Jun 18, 2006
    Do you leave your HR20 in standby or on all night? I doubt it, but standby ...could... be the culprit.
     
  5. pete4192

    pete4192 Godfather

    276
    0
    May 22, 2007
    Yes, standby. Maybe I'll try powering off completely through the next update to see if that helps.
     
Thread Status:
Not open for further replies.

Share This Page