1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Problems linking 32.0 UHF 2G

Discussion in 'ViP922 DVR Support Forum' started by jdeitchler, Apr 16, 2010.

  1. jdeitchler

    jdeitchler Mentor

    38
    0
    Oct 10, 2005
    Anyone else having problems getting the remote to link (communicate) to the receiver? The RF antenna (that came with the receiver) is installed on rear. System info screen states no remotes linked. I hold down the SAT button on the remote and it flashes green for a while, but never links. Power cycled both the receiver and the remote for 60 seconds. Verified the batteries are good, too.
     
  2. jdeitchler

    jdeitchler Mentor

    38
    0
    Oct 10, 2005
    The batteries that shipped with the remotes were garbage. Here is the process to reset your remote control. Use a VOM to measure your battery voltage and make sure they are good otherwise this wont work...

    (24DrDcb) Ben W.DFW: 1. Hold the SAT key until all mode lights turn red.
    Jason Deitchler: ok. saw them turn red
    (24DrDcb) Ben W.DFW: 2. Press Jump and 0 at the same time for 3 seconds.
    (24DrDcb) Ben W.DFW: 3. Press Search.
    (24DrDcb) Ben W.DFW: 4. Press Vol +.
    (24DrDcb) Ben W.DFW: 5. Press Stop, then wait 5 seconds.
    (24DrDcb) Ben W.DFW: 6. You should hear 3 tones confirming unlinking complete.
     
  3. MNJoe

    MNJoe New Member

    1
    0
    Mar 7, 2013
    I saw several listings for my remote but none would work. After calling tech support I was able to get it fixed so I figured I'd update this listing.

    Hold SAT until all 4 lights light (5 seconds)
    Then hold Recall and 0 for 3 Seconds
    Hit Search
    Hit + Volume
    Hit Stop

    You'll now hear the tones and then press SAT on your System Info Screen and you'll be set.

    Good Luck
     
  4. Ray C@DISH Network

    Ray C@DISH Network DISH Representative DISH Representative

    914
    1
    Dec 28, 2010
    This procedure resets the remote to any receiver it was link with. Once reset, you can link the remote to your receiver. Thanks.

     

Share This Page