1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

question about remote control

Discussion in 'General DISH™ Discussion' started by runner861, Jun 28, 2012.

  1. runner861

    runner861 Icon

    859
    0
    Mar 20, 2010
    I have a remote control for my 622 with the number 2 on the bottom. I understand that this means that it is a UHF remote control. However, I would like to use this remote as an IR remote control in the same room with the 622. My 622 is in single mode and does not have the UHF antenna attached. Is it possible to use this remote as an IR remote? If so, how do I do that?
     
  2. Ray C@DISH Network

    Ray C@DISH Network DISH Representative DISH Representative

    914
    1
    Dec 28, 2010
    If you remove the Green # 2 tab from the bottom of the remote and look at the opposite side of the tab, you should have a Blue #1 tab. This should be the correct tab to use at your TV 1 location.

    On your current TV 1 remote, press the Menu button 2 times to display the System Info screen. Towards the bottom of the screen you will see TV 1 Remote Address and TV 2 Remote Address. When programming the other remote, you want to use the same address for TV 1 Remote Address.

    The instructions for programming the remote to the receiver are below:

    1. Press the SYSTEM INFO button on the front panel of your receiver. Avoid accessing the "System Info" screen using the remote control, as this could cause re-addressing both impacted remotes.
    2. Press and hold the SAT mode button on your remote until all of the mode buttons light up - All four mode buttons should light up
    3. Use the number pad on your remote to enter a remote address between 1 and 16. The SAT button should light up
    4. Press the POUND (#) button - The SAT button should flash 3 times
    5. Press the RECORD button - If the steps are successful, the number entered in Step 4 should display on the "System Info" screen
    6. Select "Done" to close the "System Info" screen

    You need to program the remote to operate your TV, too. Please let me know if you have further questions. Thanks.

     
  3. coldsteel

    coldsteel Hall Of Fame

    1,984
    0
    Mar 29, 2007
    Well, it should be a Blue #2 and Green #1, but essentially correct.
     

Share This Page