1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Replacement 722K With MT2 OTA Module

Discussion in 'ViP612/622/722/722K DVR Support Forum' started by Jim148, Mar 19, 2012.

  1. Jim148

    Jim148 Godfather

    359
    3
    Jun 22, 2004
    I received a text from my wife inforaming me that Brown Santa (UPS) dropped something off at our farm this afternoon. I suspect it is a replacement 722k to replace mine that has developed a severe case of amnesia! Anyway, help me brainstorn and plan for the swap out. So far I have come up with:

    -Remove MT2 and install in "new" 722k

    -Check remote control addresses

    -Move recordings on internal hard drive to external hard drive

    What else should I be thinking of? Are there any tips from others that have done this recently that they want to pass along?
     
  2. Jhon69

    Jhon69 Hall Of Fame

    4,714
    5
    Mar 27, 2006
    Central San...
    Go into System Wizard "0" backup your timers to your remote control,transfer them to your other 722k.;)
     
  3. Ray C@DISH Network

    Ray C@DISH Network DISH Representative DISH Representative

    914
    1
    Dec 28, 2010
    Don't forget to remove the TV 2 remote antenna to use on your replacement receiver. When you address the remotes to the replacement receiver, the software will give the remote an address so you don't need to use the same addresses assigned from the old receiver.

    Once you reconnect all the cables to the replacement receiver, the setup wizard will walk you through the whole process. Make sure you put the cables in the exact spot from the old receiver to the replacement. If you have further questions, please let me know. Thanks.

     

Share This Page