1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Single Hopper (no Joeys) AT120+Willow Cricket HD Installation questions

Discussion in 'Hopper System Support Forum' started by BigDipperUS, Nov 18, 2013.

  1. BigDipperUS

    BigDipperUS New Member

    4
    0
    Nov 18, 2013
    Snoqualmie, WA
    Hi all. I already asked this question in the "Programming and Reception" forum but it seems like I may be able to get betters answers here :)

    I just signed up for Dish (America's Top 120) and was able to add Willow Cricket HD directly on the sign-up page (I believe it will be channel 9997 on the 118 satellite). My questions are:

    - Will Dish have to install two dishes on my roof so that I can get the regular service + Willow Cricket HD?

    - How many coax cables will have to go from outside my house to my Hopper? I only plan on having the single Hopper in my house for a single TV (no additional Hoppers or Joeys).

    The reason I asked the second question is that I would prefer Dish did not drill holes through the walls in my house if they can avoid it. There is already a Comcast box on the outside of my house where Comcast's line comes in and all the various coax outlets inside my house connect. I would love for Dish to just go from the satellite dish down into the Comcast box and then link up with the existing coaxial cable that goes to my living room.

    My house was only built last year (2012) so I assume the coax that was installed should be good enough. I think it's RG6 and I have 105mbit Comcast internet travelling over the coax to a different room in my house and that is working fine.

    I appreciate any help / suggestions!
     
  2. 3HaloODST

    3HaloODST Godfather

    472
    8
    Aug 9, 2010
    You will get a 1000+ dish (pulls in 110/118.7/119/129.) Two cables are required from the dish to the node. From there there is only one cable from the node to the Hopper. They can put a Solo Node at the dish, two feeds to the node from the dish, they should put a 75-ohm terminator on the CLIENT port of the node, then run a cable from the HOST port to the Hopper. The feed between the node and the Hopper requires 3GHz of bandwidth. Since you said it is a new house chances are they can use the existing RG6 (ONLY RG6) with the exception that they may need to replace the connectors and remove any cable equipment (splitters etc. .)

    Hopper doesn't show the 9xxx duplicates, so you should be looking for channel 712 to find Willow Cricket HD.
     
  3. BigDipperUS

    BigDipperUS New Member

    4
    0
    Nov 18, 2013
    Snoqualmie, WA
    Excellent. Thanks for the help!
     

Share This Page