1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

SWM8 whole home installation help

Discussion in 'DIRECTV Installation/MDU Discussion' started by Soccernut, Apr 9, 2013.

  1. Soccernut

    Soccernut AllStar

    197
    13
    Jan 19, 2004
    Is this correct?

    1-Power insert off SWM output 1 connected to power outlet and HR44
    2-Ethernet cable from router connect to HR44 ethernet port
    3-SWM output 2 line connected to DECA, connected to HR22
    4-DECA ethernet line connected to HR22 ethernet port

    I don't want to use splitters as these lines are already set on current setup

    Will this work for all Directv service including whole home?
     
  2. carl6

    carl6 Moderator DBSTalk Club

    12,386
    902
    Nov 15, 2005
    Seattle, WA
    Yes, that should work just fine.
     
  3. HoTat2

    HoTat2 Hall Of Fame

    7,081
    165
    Nov 16, 2005
    Los...
    With this setup make sure the SWiM-8 module is the newer "green" labeled type of course.
     
  4. peds48

    peds48 DIRECTV A-Team DBSTalk Club

    18,378
    906
    Jan 10, 2008
    NY
    Also if you have an AC outlet near the SWM8 switch, I would connect the power supply to the legacy port #3. I don't like "shrugs" to have the power supply behind any receiver
     
  5. Soccernut

    Soccernut AllStar

    197
    13
    Jan 19, 2004
    Thank you all.
     

Share This Page