1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Welcome to the new DBSTalk community platform. We have recently migrated to a community platform called Xenfono and hope you will find this change to your liking. There are some differences, but for the most part, if you just post and read, that will all be the same. If you have questions, please post them in the Forum Support area. Thanks!

Using HR24 wirelessly with HR34 without coax -

Discussion in 'DIRECTV HD DVR/Receiver Discussion' started by brucknerdoc, Dec 22, 2012.

  1. brucknerdoc

    brucknerdoc Cool Member

    30
    0
    Dec 26, 2006
    A year ago or so, I had a couple of HR24's - each having their own coax run - that also connected wirelessly to each other, sharing the DVR. This was done thru an Airport extreme wireless network.

    After moving, I only had one cable run and only used the single HR24.

    Last week, I installed an HR34 (which works fine). What I'm trying to do is connect my HR24 in another room (without a coax) so I can access the DVR on the HR34.

    When I set this up (again, using an Airport extreme wireless network), the HR34 tells me it is authorized for whole-home dvd, but doesn't see the HR24 - and the HR24 tells me it is not authorized.

    If I move the HR24 to connect to the single coax feed (disconnecting the HR34), the HR24 now reports it is authorized and sees the recordings on the HR34 (same wireless network connections) - even with no coax into the HR34.

    When I had the HR24 installed alone, it was connected with a CCK-W - so I tried using this instead of one of the Airport extremes with no change.

    Confused...
     
  2. veryoldschool

    veryoldschool Lifetime Achiever DBSTalk Club

    42,649
    338
    Dec 9, 2006
    The receivers need/must be, connected to the SAT feed. This is where they get their authorization.
     
  3. brucknerdoc

    brucknerdoc Cool Member

    30
    0
    Dec 26, 2006
    Thanks -

    The HR34 worked without the coax, but maybe that was because it was connected at boot (before I switched it over to the HR24). Maybe if I run a long coax to the room with the HR24 so it's connected at boot... :rolleyes: Be a bummer every time I lose power :eek2:

    What would really be nice is to run the HR24 as an RVU client to the HR34 - need to release some sort of product for legacy units :)
     

Share This Page