1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

VIP 622 Audio pops on TV2

Discussion in 'ViP612/622/722/722K DVR Support Forum' started by SE_Sooner, Nov 7, 2008.

  1. SE_Sooner

    SE_Sooner AllStar

    52
    0
    Aug 12, 2008
    My VIP 622 has audio distortion on the coax output for tv 2. It comes and goes but gets so bad at times you can't hear the audio. This only happens on the coax output, I tried direct to the a/v output and the audio's fine. I've also ran a new coax directly to tv2 but had the same problem and also tried a different TV. Still no luck.

    Has anyone else seen this problem? Any help is appreciated.
     
  2. Michael P

    Michael P Hall Of Fame

    3,107
    21
    Oct 27, 2004
    Perhaps the RF signal is too hot for your 2nd TV. They suggest using an attunuator on the RF line if only one TV is connected on a short line. The output is "hot" on purpouse so you can use spitters and/or long cable lengths.

    Also have you tried a different TV on the line? Perhaps the tuner on your 2nd Tv does not like the signal buit another one can tolerate it.
     

Share This Page