Hello everyone! I have been reading DBStalk for sometime now but this is my 1st post... I am so nervous now... ok... Got a question(s) for the community.. 1) I just finished upgrading my system with an AT9 / Zinwell 6x8 / HR10-250 set up (this all goes to my new Samsung 1080p DLP, awesome!!). The AT9 replaced my dual round dish and it looks awesome and I get mid-90's on most SAT's.. it was fun to install... but when I run through the Zinwell some of the Sat's aren't seen anymore (I can see the 101 sat but not the 110 or the 119). I proved it wasn't the HR10-250 or the AT9( by bypassing the Zinwell using 2x inline couplers sending to feeds from the AT9 directly to the HR10-250... everything works great that way but when I reintroduce the Zinwell... it doesn't go Sowell.. Do I have a bad Zinwell or do I have something misunderstood about the multiswitch? 2) What is the best HD OTA antennas available for a tower just over 50 miles away? I am thinking I will need 2 OTA antennas to get both the Rockford, IL towers (fairly close and clumped around 260-266 degrees.) and the towers in Madison, WI. (approx. 58 miles away and at 333-336 degrees.) 3) Can I (if the Zinwell 6x8 works) cascade with another 3x4 multiswitch (so I can continue to use my Sony T60 Tivo unit along side my HR10-250, this would require 4 feeds instead of the 2 already in the living room.) The setup would be the following: AT9 (4 SAT feeds) into the 6x8 multiswitch (not using the flexports) with 2 output feeds going into a 3x4 multiswitch which would feed all 4 inputs of the HR10-250 (2) & the Sony T60 (2). 4) I got the HR10-250 for a steal and am awaiting D* to release the HR20 PVR units so I can pick it one up... will there be any issues with my setup and Mpeg4? phew! So many questions... I saved them all for today! Thanks for a great site!!