My 622 went into a constant reboot situation. Sometimes when I pulled the plug for 10 sec and reconnect, it would be corrected. Othertimes it would not be. I called DISH and they sent me a quick replacement receiver. However, this one does the same thing! I did find out that if I disconnect the HDMI cable (which goes into a Lumagen video processor), it would boot up fine and then I could plug the cable back in. Sometimes I have no issues at all, but this all started about a month ago. None of the other equipment has been firmware updated except the 622 which does it automatically. I've never had any issues with this setup. Any ideas?
Welcome to DBSTalk
Like most online communities you must register to view or post in our community. Sign-up is a free and simple process that requires minimal information. Be a part of our community by signing in or creating an account. The Digital Bit Stream starts here!
- Reply to existing topics or start a discussion of your own
- Subscribe to topics and forums and get email updates
- Send private personal messages (PM) to other forum members
- Customize your profile page and make new friends
622 constant reboot
Posted 19 April 2013 - 09:05 AM
||...Ads Help To Support This Site...||
Posted 19 April 2013 - 01:46 PM
Posted 19 April 2013 - 07:29 PM
try to disablle CEC pins by using two complimentary HDMI-DVI /DVI-HDMI cables/dongles
Posted 03 May 2013 - 08:59 AM
Posted 03 May 2013 - 10:47 AM
did you try the simplest solution ? two cables ?
Posted 03 May 2013 - 02:47 PM
Posted 03 May 2013 - 03:20 PM
if you would try the cable, you will know where is the problem .. at lease will know is it CEC channel or not ?
Posted 04 May 2013 - 03:18 PM
I found a couple of DVI/HDMI adaptors and will try it out... Thanks for the suggestion. SJ
Update: Did not help. Issue still exists.
Edited by SJ HART, 05 May 2013 - 04:04 PM.