Separate names with a comma.
Yep. Just repeat the Satellite Setup procedure. Specify "multiswitch" instead of "SWM" during the setup.
That message usually means that the dish isn't getting power from your Single Wire Multiswitch Power Inserter.
Could be an HDMI synch issue with your TV. What happens if you change the TV to a different video input source and then back to your HR44 source?
Perhaps something in your home is interfering with the RF signal?
What do you mean by "missing"? Any on-screen message?
If "Clearmybox" doesn't fix it, then you likely have a hard drive issue.
Not likely to happen.
Let us know your equipment model numbers ....
Dish LNB assembly?
SWM switch and splitters?
DVR/Receiver model numbers?
Most likely defective LNB. Let us know how the replacement works.
The Antenna Man exposes the real reason that providers like Dish and DirecTV have local channels yanked ....
Here we go again :(
Realize that it's Tegna that's threatening to pull your channel, not DirecTV. This is an all too common negotiating tactic...
Correct. Verify your LNB type/model and let us know what you find.
What are the model numbers of your DVRs?
What is the model number on that "SWM8"? Is it actually a 4-way splitter or SWM switch?