Separate names with a comma.
with no load ?
it would be interesting to see upper point.. what is there ? a square plate with huge bolts going up ? is it bolted to wooden raft or ?
at which point(s) ?
with LNB connected ? PI could go low voltage under load if it's partially bad
any technical info what is changed in it ?
isn't C61R2-xxx newest C61K ? or it's C61 without UHD ?
what the source ? SD ? HD ? UHD ? Ch# ?
Common rule: turn on peripheral devices like TV/projector (HDMI sink device) first, then repeaters (AVR, switch, etc ), then HDMI signal...
I would check voltage on PI, on LNB iN F-connector … perhaps on cable at LNB
connect PI to the splitter's port#1 - "pass DC"
turning off does not make any difference in turning on sequence
confused … do you have three c61k ? or it's implied system 4K decomp problem in C61K?
According 100s posts here last month, OTA does working, exclude some local glitches.
See other threads like "LCC", perhaps it's time to discard...
or RF/WiFi remote, or BT link to a headset, or any other [say ZigBee] RF technology
who is the "genie" invented such awkward dish ?!
could be, knowing how Broadcom making many versions of one chip ...
Knowing how scrutinized a procedure [R&D] of selecting chips for new device, I would oppose the opinion.
According Broadcom, main chip of the device does satellite:
if the dish have newest 3 sat LNB block - NOT
Good news - time to open new dedicated thread !!!