Separate names with a comma.
go to the advanced internet settings page, press recall, recall, play then change IP Address Configuration from automatic to manual and enter your...
The movies on 501 are all downloaded to the harddrive on your Hopper during the night from the satellite.
When you see a movie listed it can be...
Actually DISH's rule is you can have up to two owned Wallys or 211(k or z) on a Hopper account.
You can edit the individual timer to keep all.
I would much prefer to have reruns record as new rather than have new not record as a rerun.
Especially since you said you swapped the cables and the problem stayed with input 2.
The 1000.2 is used for both EA & WA.
77 is not needed for most installs that’s why you didn’t get it.
Your signals are good.
Under the advanced tab for internet settings press “recall,recall,play” that will give you the manual settings menu.
Your Receiver should quit going into standby when you turn the TV off
Maybe you need to turn HDMI-CEC off.
If you would follow the suggestion you would find DISH would work perfectly for you but since you're too stubborn.
That is the old dual tuner made by haupagge.
The new dual made by Lark doesn't run hot and works just as good as the single by Pace. (Actually better)
Thats what you would think but the OP says his Superbuddy is verifying LNB 1 as 119 and LNB 3 as 129 which would rule out being off by 9 degrees.
I think I read somewhere that the basic remote cannot be used on a Hopper.
It defaults to no because of the contracts with the networks so it will never change.
When Autohop was released on the very first Hopper it did...
You can change the channel order in the settings for the guide.
A check switch will do absolutely nothing for a guide download on a Hopper.
The only thing to do is make sure all Joeys are in standby then put...
Just plug the drives in.
No folders on the external drive.
Here's a screenshot from my H3 there is no percent.
You're the first person I've seen complain that the commercials are not as loud as the programming usually it's just the opposite so actually this...