Separate names with a comma.
[MEDIA]just giving an update.
i wound up using this setup for fast scanning of sky.
18.3-18.8 GHz (250-750mhz)
12.2-12.7 GHz (950-1450mhz)...
hr24, (2) sup-2400's and sl5k (legacy 4 port lnbf) get here tomorrow.
from what i been looking at on my limesdr-mini (1GHz and below) is messed...
im not sure if i understand.
i dont have any plan with directv (yet) not sure if the HR24 i ordered even has an access card.
i would like to have...
interesting as the same 4 ports on the swm16 can power Ka and Ku.
on wb68 same 4 ports only power Ku?
you would think it would need less ports...
so this would allow me to change rhcp and lhcp but not the 22khz tone to activate Ka-low and Ka-High?
ok i think this is it :)
i have a 2-way splitter hooked up to each swm port with an sdr on each tap.
please double check the info
im already on it without the rental.
it (looks) to me that when you add an sdr device (one at a time) to the splitter it is giving that device a...
ok im not sure whats going on here.
is my limesdr-mini (top) broken below 1ghz?
top = limesdr-mini
middle = r820t2
bottom = e4000
i have a Directv SWiM 21v PI also i could use or would the 29v PI be a better choice?
"Output Ports" = the (non-lnbf ports)?
"Output Ports" = the...
this is with (two) R820T2 sdr dongles hooked up at same time
when spectrum has change i moved both dongles over at same time
13v and 18v
now this picture's spectrum is different then when i had two sdr dongles hooked up earlier.
i had some IF in the low area of the spectrum between...
just ordered the HR24-500 off ebay and its coming with (2) sup-2400's
the SWM16 is probably going to be the best to use when a PI29 is connected...
ok i know this isnt too smart but i just ordered "DIRECTV SL5K4NR3-01" and "DirecTV Slimline SL5S4NR2-02"
sometime i will get the hr24 but not...
when the 4 (2 way splitters) get here im going to put one rtlsdr dongle on each of the lnbf outputs to the swm16 and then im going to use my...
(4) MSPLIT2R1-03 to replace my (2) MSPLIT8R1-01 to save some space.
(1) Zinwell WB68 6x8 Multi-Switch to replace my SWM16.
you mean 99 or 103?
i not sure how to tell.
im still not sure if im supposed to be on 79degree skew on its reading or if it should be 101degrees....
all 4 cables hooked up.
tap is on the "18v" only
bottom of picture = both Ka ports covered and Ku port open
next reading = right Ka port open and...
these are just (4) images over the whole range but i did leave all 4 cables connected from all lnbf's to the 4 ports on swm16.
i just moved...
all feed horns uncovered.
SWiM16 connected to LNBF with one cable only.
moving the cable to each port on swm16
top to bottom:
should i cover up the Ku feed horn and uncover one Ka feed horn at a time?
what voltage and khz should i couple off of?