Separate names with a comma.
Best Answer: External Hard Drive
I have a 10 TB drive on a Genie thus no problem recording for days
2TB is limit for HR24
What Channel List is the HR54 set to.
Are the OTA channels checked in the "list" you are using??
Just to try before CSR roulette, completely reset the Mini.
Hold the Red Button on the mini in for 20 to 30 secs before releasing. May need to do...
AT&T T16 at Geostationary Orbit at 139 degrees W
Ready for IOT
TLE_17 Orbit 11:
1 44333U 19034A 19177.87427323 .00000127...
ATT-16 Launch Info:
Ariane Flight VA248 - Arianespace
Just to spice things up:
No New channels but all Spanish and International channels are now ACTIVE on Sat 99cr (reverse band)
I don't think the picture tells the whole story!
There appears to be 5 or more unused cables. Another unused line is barely visible in the bottom...
I've used it in the past.
Works great with good UPLOAD internet.
Unfortunately ,in my present setup, DSL with only ~ 1.5 mb/sec upload is barely...
T16 application posted on FCC website:
Notify going to License
Magic 8 ball says:
That will be just as accurate!
Not technically Satellite HD but OTA entries updated in 12 Markets today (~61 Ch entries)
Go to gct's SAT/TPN/Channel grids and actually look at what is on SAT 101.
All the CINE/ MUSIC / SPORTS channels could be on 99/103. Probably all...
It appears that you are going to have to try it and tell US
AIM 1.5 Advanced Installation Meter for DIRECTV Satellite Dishes (AIM15) from Solid Signal
Did you redo setup to match situation you are trying to test?
Also from your other thread, be very careful testing anything on the downside of...
I think the 4 ways are your problems.
Even if you put 2 at each 4 way the line signal drop will be less.
Call Solid Signal or Sonora Design or...
You can use other switches off the "trunk" line but the SWM 5 in his diagram is the ODU not a SWM5 switch . Likely a 5LNB dish (and not really a...
I'm no installer but I believe your issue is signal loss due to splitters rather than taps.
What rooms specifically are having problems.
Best option is to match Dish/LNB at both sites.
If trying to go from SWM site to Legacy, I found that setting the receiver to 18 in round dish,...