Separate names with a comma.
Thank you. I will see if I can bend it in to hit that spot. Appreciate the info!
As best as I can tell, it will hit in between the bolts about an inch or so higher than the top bolts.
Where is it supposed to hit the reflector? Then I can see if it hits the correct spot.
everything is straight against a straight edge.
Just brought a straight edge out and it is straight.
It is RG6 cable. When I did the initial setup, I took a small TV and extension cord out to the dish with a short (less than 20 feet) coax. The...
I have tried that. Moving the dish left or right the width of a pencil line drops the 101W strength from 80 to the upper 60's. That's part of...
I receive all channels on 101 just fine. I also receive some HD channels (somewhat glitchy) from 99 and 103.
Here is the situation. I set up an SL3 dish and the elevation is supposed to be 33. When I first was searching for signal, I hadn't set my...