DBSTalk Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-20 of 494 Results
  1. Hopper System Support Forum
    OK I g working, but not sure which of 3 methods fixed it. First I hadn't fully linked the Harmony skill with Alexa, which led me to be able to link my Hopper to the Harmony app. Then I tried mapping an unused key on the Harmony remote to DVR. After doing all three of those the DVR button...
  2. Hopper System Support Forum
    I recently purchased this remote and am using it with HWS and have an echo dot with Dish skill. I love the way it all works and the hub is a masterpiece of engineering. The only problem is I can't get the DVR button on the remote to work. The Harmony 880 it replaced had a list button on the...
  3. Hopper System Support Forum
    See post # 5. That is all there is to it. I replaced a Hopper 2 that was having the same problem you describe. Settings were backed up in the remote and when I restored them everything worked as it had before. It was dead simple.
  4. General DISH™ Discussion
    I have used TWC, DTV & U-Verse and I think Dish is hands down the best channel guide layout - BY FAR!!
  5. General DISH™ Discussion
    I suspect that it is difficult to "offer" more without significantly increasing the price. I think they are trying to keep the price as low as possible to entice all of the cord-cutters who are looking to get as much as possible for low cost or free. Once the free/low cost online content...
  6. Hopper System Support Forum
    You might try swapping the wires to the Joey and see if the problem follows.
  7. DISH™ High Definition Discussion
    I didn't think so.
  8. Hopper System Support Forum
    So how did you make out?
  9. Hopper System Support Forum
    This is not true, there are many reports of people upgrading to H3 plus multiple 4K Joeys. The limit is 6 Joeys (5 leased) per H3 and all can be 4K Joeys if you are willing to pony up the $50 up front for each leased 4K Joey and purchase # 6 outright. I am not sure how many 4K feeds the MOCA...
  10. Hopper System Support Forum
    The old Hopper remotes with the color buttons work fine on the Hopper 3. That is why they are still there.
  11. Hopper System Support Forum
    The old 40.0 remotes most certainly do work with the new Hopper 3!!
  12. Hopper System Support Forum
    You either have to turn PTAT off or change the number of save days to a lower number to transfer PTAT programs.
  13. General DISH™ Discussion
    The Hopper should not be cutting off the end of your shows if you set the defaults properly unless you have timers set for every tuner and the shows have to cut off to start the next show. It is the networks that sometimes run past the top and bottom of the hour that can cause a problem if you...
  14. Hopper System Support Forum
    Billing should stay the same if swapping new equipment for old.
  15. DISH™ High Definition Discussion
    Anyone have a link to a recent side by side comparison of E* and D* picture quality conducted double blind under matched and controlled conditions?
  16. General DISH™ Discussion
    http://www.forbes.com/sites/realspin/2014/02/07/when-it-comes-to-high-speed-internet-the-grass-isnt-greener-in-europe/#17b3421d6231
  17. General DISH™ Discussion
    Phrelin, do you think that when the number of "cord-nevers" and "cord-cutters" reaches a tipping point that the content owners will still continue to give the milk away for free? I have to think that when streaming becomes more mainstream you will see content owners raise the rates for...
  18. General DISH™ Discussion
    Yeah, who gets the fine, the victim of the call or the state? How many guesses do I get? :)
  19. General DISH™ Discussion
    I hate these calls too and I get them all the time. I just don't answer the phone and they NEVER leave a message. That said, it is a minor annoyance at most. BTW I have never been called by Dish resellers.
  20. Hopper System Support Forum
    I have read several reports of people having to do this with a Hopper 3 with terrible picture out of the box. The reports I read said this fixed the issue.
1-20 of 494 Results
Top